Adding Network to Wallet
To interact with WireFluid using an EVM wallet such as MetaMask, the network must be added manually. This connection enables you to send transactions, deploy contracts, and interact with dApps directly on the WireFluid chain.
Connection Parameters
Enter the following details exactly as shown to configure your wallet.
| Parameter | Value |
|---|---|
| Network Name | WireFluid Testnet |
| RPC URL | https://evm.wirefluid.com |
| Chain ID | 92533 |
| Currency Symbol | WIRE |
| Block Explorer | https://wirefluidscan.com/ |
Steps to Add WireFluid to MetaMask
-
Open MetaMask Click the fox icon in your browser toolbar and click the network selector (top-left corner).
-
Add Network Select Add network from the dropdown, then click Add a network manually at the bottom of the list.
-
Enter Details Copy and paste the Connection Parameters from the table above into the corresponding fields.
-
Save & Switch Click Save. You can now switch to the WireFluid Testnet network.
Performance & Gas Notes
Once connected, your wallet will interact with the WireFluid high-performance network.
- Fast Finality: Transactions on WireFluid finalize in approximately 5 seconds.
- Low Cost: Average gas fees are extremely low, ranging from 0.00024 to 0.0017 WIRE per transaction.
- Compatibility: Existing Ethereum accounts and private keys work seamlessly on WireFluid without any reconfiguration.
Next Steps
- Get WireFluid Faucet → - Request free tokens to start sending transactions.